Skip to main navigation Skip to search Skip to main content

Surface phase, morphology, and charge distribution transitions on vacuum and ambient annealed SrTi O3 (100)

  • Omur E. Dagdeviren
  • , Georg H. Simon
  • , Ke Zou
  • , Fred J. Walker
  • , Charles Ahn
  • , Eric I. Altman
  • , Udo D. Schwarz
  • Yale University

Research output: Contribution to journal › Journal Article › peer-review

40 Citations (Scopus)

Abstract

The surface structures of SrTiO3 (100) single crystals were examined as a function of annealing time and temperature in either oxygen atmosphere or ultrahigh vacuum (UHV) using noncontact atomic force microscopy (NC-AFM), Auger electron spectroscopy (AES), and low-energy electron diffraction (LEED). Samples were subsequently analyzed for the effect the modulation of their charge distribution had on their surface potential. It was found that the evolution of the SrTiO3 surface roughness, stoichiometry, and reconstruction depends on the preparation scheme. LEED revealed phase transitions from a (1×1) termination to an intermediate c(4×2) reconstruction to ultimately a (√13×√13)-R33.7 surface phase when the surface was annealed in an oxygen flux, while the reverse transition from (√13×√13)-R33.7 to c(4×2) was observed when samples were annealed in UHV. When the surface reverted to c(4×2), AES data indicated decreases in both the surface Ti and O concentrations. These findings were corroborated by NC-AFM imaging, where initially TiO2-terminated crystals developed half-unit cell high steps following UHV annealing, which is typically attributed to a mix of SrO and TiO2 terminations. Surface roughness evolved nonmonotonically with UHV annealing temperature, which is explained by electrostatic modulations of the surface potential caused by increasing oxygen depletion. This was further corroborated by experiments in which the apparent roughness tracked in NC-AFM could be correlated with changes in the surface charge distribution that were controlled by applying a bias voltage to the sample. Based on these findings, it is suggested that careful selection of preparation procedures combined with application of an electric field may be used to tune the properties of thin films grown on SrTiO3.

Original languageEnglish
Article number195303
JournalPhysical Review B
Volume93
Issue number19
DOIs
Publication statusPublished - 4 May 2016
Externally publishedYes

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Condensed Matter Physics

Fingerprint

Dive into the research topics of 'Surface phase, morphology, and charge distribution transitions on vacuum and ambient annealed SrTi O3 (100)'. These topics are generated from the title and abstract of the publication. Together, they form a unique fingerprint.

Cite this