Passer à la navigation principale Passer à la recherche Passer au contenu principal

Effects of Trace Elements on the Microstructural and Machinability Characteristics of Al–Si–Cu–Mg Castings

  • Yasser Zedan
  • , Agnes M. Samuel
  • , Herbert W. Doty
  • , Victor Songmene
  • , Fawzy H. Samuel
  • École de technologie supérieure
  • General Motors
  • Université du Québec à Chicoutimi

Résultats de recherche: Contribution à un journal › Article publié dans une revue, révisé par les pairs › Revue par des pairs

9 Citations (Scopus)

Résumé

This study was undertaken to emphasize the influence of Sn and Bi addition on the machinability of Sr-modified, grain-refined, and heat-treated Al–Si B319 and 396 alloys. Drilling and tapping tests were conducted to examine the cutting forces, tool life, tool wear, built-up edge evolution, and chip shape. Microstructures were examined using optical and electron microscopy. Drilling test results show that the B319.2 alloy with 0.15%Sn yields the longest drill life, i.e., twice that of the B319.2 alloy containing 0.5%Bi, and one-and-a-half times that of the B319.2 alloy containing 0.15%Sn + 0.5%Bi. The presence of 0.5%Bi in the B319.2 alloy causes a deterioration of drill life (cf., 1101 holes with 2100 holes drilled in the B319.2 alloy containing 0.15%Sn). The α-Fe phase in the 396 alloy produces the highest number of holes drilled compared with alloys containing sludge or β-Fe. The presence of sludge decreases the drill life by 50%. Built-up edge (BUE) measurements and optical photographs show little change in the BUE width for different numbers of holes except for the B319.2 alloy containing 0.5%Bi, which shows a slightly lower width (0.166 mm) compared with that containing 0.15% Sn (0.184 mm) or 0.15%Sn + 0.5%Bi (0.170 mm).

Langue originaleAnglais
Numéro d'article377
RevueMaterials
Volume15
Numéro de publication1
Les DOIs
ÉtatPublié - 1 janv. 2022

Classification disciplinaire ASJC Scopus

  • Sciences générales des matériaux
  • Physique de la matière condensée

Empreinte digitale

Voici les principaux termes ou expressions associés à « Effects of Trace Elements on the Microstructural and Machinability Characteristics of Al–Si–Cu–Mg Castings ». Ces libellés thématiques sont générés à partir du titre et du résumé de la publication. Ensemble, ils forment une empreinte digitale unique.

Citer cette ressource