Passer à la navigation principale Passer à la recherche Passer au contenu principal

Material extrusion additive manufacturing of low-viscosity metallic feedstocks: Performances of the plunger-based approach

  • École de technologie supérieure

Résultats de recherche: Contribution à un journal › Article publié dans une revue, révisé par les pairs › Revue par des pairs

37 Citations (Scopus)

Résumé

In recent years, increasing attention has been directed at the material extrusion additive manufacturing of highly-filled polymers (MEAM-HP). This is because conventional polymer 3D printers, which are low cost and readily available, can easily be adapted for use with metal powder-filled polymer filaments. However, fabricating the latter is time-consuming and their formulations differ from regular metal injection molding (MIM) feedstocks by lower powder solids loadings and higher elastomer contents, thus requiring significant efforts to optimize their debinding and sintering conditions. Favorably, other types of MEAM-HP printers, such as screw- and piston-based ones, can process available MIM feedstocks and apply the debinding and sintering procedures that have already been optimized. In this study, a novel ram extruder-based printer with a 100 mm-diameter ― 250 mm-high build volume was developed to print a low-viscosity MIM feedstock composed of 65% of 17–4PH powder, 23 % of paraffin wax, 10% of ethylene vinyl acetate and 2 % of stearic acid (all in vol%). The printer calibration and the process optimization procedures are detailed herein. The kinematic accuracy of the build platform revealed a maximum deviation of 29 and 92 µm in the vertical (Z) and horizontal (XY) directions, respectively. Prior to printing, a relative feedstock density of 99.8 % was obtained using a one-minute degassing procedure. During printing, a 52.5 °C build platform temperature was used and an 85 °C extrusion temperature conferred to the feedstock a viscosity of 142 Pa·s at a shear strain rate of 180 s-1 (Ø0.4 mm E3D V6 nozzle, 1 mm3/s flow rate). Indirect measurements of the extrusion pressure using a load cell positioned under the piston allowed to maximize the accuracy of start/stop extrusion sequences by adjusting the retraction volumes. An overlap printing path technique was introduced to eliminate typical MEAM voids between printed lines. Finally, six parts exhibiting complex geometries were printed to validate the capacity of the printer to produce functional components using conventional low-viscosity MIM feedstocks.

Langue originaleAnglais
Numéro d'article103252
RevueAdditive Manufacturing
Volume60
Numéro de publicationPart A
Les DOIs
ÉtatPublié - déc. 2022

SDG des Nations Unies

Ce résultat contribue à ou aux Objectifs de développement durable suivants

  1. SDG 9 – Industrie, innovation et infrastructure
    SDG 9 – Industrie, innovation et infrastructure

Classification disciplinaire ASJC Scopus

  • Ingénierie biomédicale
  • Sciences générales des matériaux
  • Ingénierie (divers)
  • Ingénierie industrielle et de fabrication

Empreinte digitale

Voici les principaux termes ou expressions associés à « Material extrusion additive manufacturing of low-viscosity metallic feedstocks: Performances of the plunger-based approach ». Ces libellés thématiques sont générés à partir du titre et du résumé de la publication. Ensemble, ils forment une empreinte digitale unique.

Citer cette ressource